ZYYX Pro build-plate optimized for hard-to-print materials that shrinks much and tend to warp, like ABS. Also works fine for ASA, Nylon and TPEE. Uses a different principle, where the raft sticks hard to the holes.
Use a ZYYX spatula to remove the raft from the build-plate by cutting the “knobs”. Our new ZX307 ZYYX stainless steel buildplate spatula scraper is recommended.
ZYYX Pro: all models
ZYYX+: NO (see ZX508 Perforated Build-Plate for ZYYX+)
ZYYX/ZYYX Classic: NO (see above for ZYYX+)
Instructions for Use
Use the designated Profiles for the ZYYX perf board or adjust the following settings in Simplify3D:
Z offset: ABS/ASA = -1 mm (print 1 mm closer), other materials = -0.5 mm (print 0.5 mm closer)
First layer settings: First layer height 250%, first layer width 250%, first layer speed: 20%, Layer 1 temperature: +5-10 C.
Additions/Raft: Top layers 2, Base layers 4, Offset from part 4 mm.