ZYYX Pro build-plate optimized for hard-to-print materials that shrinks much and tend to warp, like ABS. Also works fine for ASA, Nylon and TPEE. Uses a different principle, where the raft sticks hard to the holes.
Use a ZYYX spatula to remove the raft from the build-plate by cutting the “knobs”. Our new M2.0946 ZYYX stainless steel buildplate spatula scraper is recommended.
ZYYX Pro: all models
ZYYX+: NO (see ZX508 Perforated Build-Plate for ZYYX+)
ZYYX/ZYYX Classic: NO (see above for ZYYX+)
Instructions for Use
Use the designated Profiles for the ZYYX perf board or the following settings:
Z offset: ABS/ASA = +1 mm (print 1 mm closer), other materials = +0.5 mm (print 0.5 mm closer)
Bottom layer raft setting: First layer speed: 30%, Layer 1 temperature: +5-10 C.
Use 3 Raft Base Layers.